- SMPTE ST 2110 carries video, audio and data as separate IP streams.
- Sync comes from PTP, defined for broadcast by SMPTE ST 2059.
- Redundancy uses two independent networks, under SMPTE ST 2022-7.
- NMOS handles discovery and connection between equipment from different manufacturers.
- Uncompressed video needs a lot of bandwidth: about 2.5 Gb/s in 1080p and 10 Gb/s in 4K.
On this page
Short answer
SMPTE ST 2110 is a family of standards from the Society of Motion Picture and Television Engineers that defines how to carry broadcast video, audio and ancillary data over IP networks, inside a station or an OB truck. Instead of one SDI cable carrying everything together, each element becomes a separate IP stream, synchronized by a network clock. The result is an infrastructure where network switches do the job of the router, signals can go anywhere and one cable carries dozens of signals.
Why TV is moving to IP
SDI has worked well for decades, but every signal needs its own cable and its own router port. In 4K, one signal needs 12G SDI or four 3G cables. A large station piles up thousands of cables and huge routers. Over IP, one 100 Gb/s fiber carries many signals, the network grows by adding switches and the same principles apply inside the building and between buildings. The comparison SDI or IP shows when each one makes more sense.
The parts of the standard
ST 2110 is split into parts, each covering one type of content or one common rule:
- ST 2110-10: system and timing, the common base for all the other parts.
- ST 2110-20: uncompressed video, with the active picture carried in RTP packets.
- ST 2110-21: traffic shaping rules for sending packets, so the network and receivers do not choke.
- ST 2110-22: low-latency compressed video, such as JPEG XS, to save bandwidth.
- ST 2110-30: PCM audio, compatible with AES67.
- ST 2110-31: transparent AES3 transport, for compressed audio or audio with metadata.
- ST 2110-40: ancillary data, such as closed captions, timecode and metadata.
Separating the essences is one of the big advantages. An audio device receives only the audio, with no need to de-embed it from the video. A caption generator receives only the data it cares about.
Sync: PTP instead of genlock
In SDI, sync comes from a reference signal distributed by cable, genlock. In ST 2110, every device syncs to a grandmaster clock over the network itself, using the Precision Time Protocol, PTP, from IEEE 1588, with the broadcast profile defined by SMPTE ST 2059. Every packet carries the exact time it was created, and the receiver lines up video, audio and data even when they arrive by different routes. That is why the PTP design, with redundant grandmasters and suitable switches, is a central piece of the network.
Redundancy: two networks
Common practice is to build two independent networks, often called network A and network B, or red and blue. Each stream leaves on both at the same time, and the receiver rebuilds the signal from whichever packets arrive first, under SMPTE ST 2022-7. If an entire network fails, the picture continues without a cut.
NMOS: what makes everything talk
Having streams on the network is not enough: something needs to know which ones exist and connect source to destination. The NMOS specifications from the Advanced Media Workflow Association, AMWA, handle that. IS-04 does discovery and registration of devices on the network. IS-05 manages connections, the equivalent of taking a router crosspoint. With NMOS, the control system commands equipment from different manufacturers in a standard way. When you buy, check that the device implements NMOS and has been through interoperability testing, such as the JT-NM Tested events.
How much bandwidth a signal takes
- HD 1080i at 59.94: about 1.3 Gb/s per uncompressed video stream.
- HD 1080p at 59.94: about 2.5 to 2.6 Gb/s.
- UHD 4K 2160p at 59.94: about 10 to 10.5 Gb/s.
- Audio: a few Mb/s per channel group, next to nothing compared with video.
That is why ST 2110 networks use 10, 25 or 100 Gb/s ports on devices and 100 Gb/s or faster links between switches. When bandwidth is limited, ST 2110-22 with JPEG XS cuts the volume sharply with a delay of only a few picture lines.
Before you buy switches, do the stream math: how many sources, in what format, to how many simultaneous destinations, with headroom to grow. IP broadcast networks fail more often from lack of bandwidth and multicast planning than from faulty equipment.
SMPTE ST 2110 or NDI
Both carry video over IP, but for different uses. ST 2110 is designed for broadcast infrastructure: uncompressed or lightly compressed, with precise sync and dedicated networks. NDI uses compression, runs on ordinary networks and is widely used in smaller live productions and streaming. The comparison SMPTE 2110 or NDI covers the differences.
When to move to ST 2110
- 01Pick the momentNew projects, major rebuilds of the technical center and the move to 4K are the natural moments. Replacing a working SDI station just for the sake of it rarely pays off.
- 02Start at the coreMany stations start with routing and master control, and keep SDI at the edges using converters.
- 03Plan network, PTP and control togetherSwitches, grandmasters, NMOS and the control system are part of the same project. Buying them separately creates incompatibilities.
- 04Train the teamVideo engineers start dealing with multicast, VLANs and PTP. Training belongs in the budget.
- 05Monitor from day oneMonitoring tools for IP streams and PTP show problems that do not appear in the picture until it is too late.
Moving to IP also prepares a station for TV 3.0, Brazil's next-generation broadcast standard, whose transport is IP-based.
How i9 works with SMPTE ST 2110
i9TV designs and integrates IP and SMPTE ST 2110 infrastructure for broadcasters and technical centers: network, sync, control and coexistence with existing SDI.
We also integrate routing matrices, such as the Ross matrix at Record Manaus and the Evertz matrix at Times Brasil · CNBC.
If your station is deciding between SDI, IP or a hybrid path, the engineering and design team runs the survey and proposes a staged transition.
i9 does this every day: production, broadcast, engineering and equipment, with one team accountable from start to finish.